Ground sleeve installation

They come in many different sizes and qualities, so you want to make sure and find the right one for your needs. Here are instructions on how to install a flagpole that will show off your pride for years to come. Be sure to take it one step at a time. This process will only be as efficient as the tools and materials that you use to install the flagpole. After you purchase a trusted flagpole, such as the Titan Telescoping Flagpole kit , you just need the right utensils to get the job done.

As far as materials go, you will need up to pounds worth of pre-mix concrete, 15 to 20 pounds of pea gravel, and water. Then, for tools, make sure you have a post hole digger, level, tape measure, and a bucket to mix the concrete inside of. The hole will be over two feet deep, so dig carefully and stop if you notice any wiring or piping below.

If you want to locate the utility lines before you dig, then you can perform a landscape analysis to find out. The pea gravel will help with this process, but more on that in a minute. If your order is tax-exempt then you must call our customer service department and provide proper documentation in order to create a tax-exempt account.

If you are logged in under a tax-exempt account and the Order Summary page is still showing taxes, then please contact customer service at Skip to the end of the images gallery. Skip to the beginning of the images gallery.

Be the first to review this product. Installation Guides. Installation Guide. HD Tennis. Tube, 8' x 24' without net supports, Permanent Aluminum. Tube, 8' x 24' without net supports, Permanent Steel. Tube, 8' x 24' with 2 net supports, Permanent Aluminum. Tube, 8' x 24' with 2 net supports, Permanent Steel. Tube, 8' x 24' with European Style net supports, Permanent A.

There are gaps in the sleeve that will allow water into it. The ground sleeve has a tiny bump-out in the rear of in which you will place a metal clip and set-screw. The problem is that this lets water in there, which will probably allow the pole and sleeve to rust together in a few years if not sealed.

The manufacturer could improve this by offering some sort of rubber cap that could block water from entering the base of the sleeve. I recommend putting silicone around the top of the sleeve and in the spots where it connects with a pole. I did the friction tape as instructed, but still spinning pretty loosely with light pressure. It seems that the friction tape that comes with the product, used to stop spinning, was low-quality. When I pulled it out, it looked to have become soft and began falling apart.

I tightened the cap real strong, and that helped, but ultimately the tape wore down. I replaced it with some great non-skid tape from the hardware store. So far, so good.